Connecting your appliance to Command Center


You can remotely manage your Untangle appliances using Command Center. This requires that your Untangle NG Firewall is configured to connect to Command Center. 


The initial setup wizard confirms whether you want to enable Command Center connectivity and prompts you to register the appliance to your Command Center account. If you need to change your selection, you can manage this option through the NG Firewall administration.

To connect or disconnect Untangle NG Firewall with Command Center:

  1. Log in to the Untangle NG Firewall administration interface.
  2. Go to Config -> System -> Support.
  3. Enable or disable Connect to Command Center.
  4. Click Save


After confirming that your appliance is connecting to Command Center, you must register the appliance to your account to remotely manage the appliance.

Was this article helpful?
5 out of 10 found this helpful
Have more questions? Submit a request



Please sign in to leave a comment.

Powered by Zendesk