Connecting your appliance to ETM Dashboard

Overview

You can remotely manage your Edge Threat Management appliances using Command Center. This requires that your NG Firewall is configured to connect to ETM Dashboard. 

Configuration

The initial setup wizard confirms whether you want to enable ETM Dashboard connectivity and prompts you to register the appliance to your ETM Dashboard account. If you need to change your selection, you can manage this option through the NG Firewall administration.

To connect or disconnect NG Firewall with ETM Dashboard:

1. Log in to the NG Firewall administration interface.
2. Go to Config > System > Support.
3. Enable or disable Connect to ETM Dashboard.
4. Click Save.
   

After confirming that your appliance is connecting to ETM Dashboard, you must register the appliance to your account to remotely manage the appliance.