Adding Untangle NGFW or SD-WAN Router to Command Center

If you have multiple Untangle SD-WAN Router and Untangle NG Firewall appliances you'll find it easier to access them all from Command Center. Command Center is Untangle's cloud-based centralized management system. It provides the ability to get visibility into all your deployments and access them with a single login.

IMPORTANT: If the appliance is already registered to another account, the account owner must remove the appliance before proceeding.

To add an appliance in Command Center:

1. Locate the serial number on the bottom side of your eSeries or zSeries appliance. If you do not have a serial number, you can use the UID of your Untangle software installation. You can find the UID by going to the administrative interface of your Untangle appliance:
   • For NG Firewall, look in Config > About:
     
     
   • For SD-WAN Router, look in Settings > System > About:
     
2. Log in to Command Center.
3. Navigate to Appliances.
4. Click Add.
   
   
5. Enter the serial number or UID of the appliance you are adding and click Add.

The new appliance appears in the appliance grid on the Command Center dashboard.

NOTE: It's useful to add a Tag for your new appliance so that it is easy recognizable, especially if you plan to add more appliances. The Tag is a friendly name that will make it easy for you to recognize your appliance. To set a Tag in Command Center, navigate to Appliances and select your newly-added appliance, then click Set Tag.